HPE Community
ProLiant Servers (ML,DL,SL)
1752705 Members
6125 Online
108789 Solutions
New Discussion

P410i RAID Contoller in an HP DL380 G7

 
pkeeslar
Occasional Contributor

‎04-07-2016 08:10 PM

‎04-07-2016 08:10 PM

P410i RAID Contoller in an HP DL380 G7

After 3.5 years of use replaced the system board due to P410i RAID controller failure.  New System board shows P410i RAID controller failure...just like old system board.  New board seems to work fine other than that.  RAID must be set to 1 + 0.  System is worthless without RAID.  System is SOL 10 X86.  Thanks for any help you can provide. 

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎04-07-2016 11:20 PM

‎04-07-2016 11:20 PM

Re: P410i RAID Contoller in an HP DL380 G7

Even a bad cache module may cause this. You replaced the controller, did you replace the cache too?


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.