HPE Community
ProLiant Servers (ML,DL,SL)
1751913 Members
4836 Online
108783 Solutions
New Discussion

Smartstart Test vs Diagnostics

 
raan2222
New Member

‎08-19-2016 02:15 AM

‎08-19-2016 02:15 AM

Smartstart Test vs Diagnostics

Hi everybody!

Does anybody have knowledge about different between Test and Diagnostics in HP smartstart disk?

I have DL360G7 with array controller P410i with two HDD sff 300GB RAID1.

There are no any error during and after test storage but I have error code F155 on diagnostics.

Why so?

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎08-19-2016 04:56 AM - edited ‎08-19-2016 04:57 AM

‎08-19-2016 04:56 AM - edited ‎08-19-2016 04:57 AM

Re: Smartstart Test vs Diagnostics

I would do the same test using the diagnostics from SPP 2016.04 first.

Smartstart is meanwhile a bit outdated ...

 

In case of doubt open a call at HPE and send them an ADU report.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.