HPE Community
ProLiant Servers (ML,DL,SL)
1751867 Members
5414 Online
108782 Solutions
New Discussion

replcaing motherboard and keep array in place

 
paristotle
New Member

‎11-23-2013 01:31 PM

‎11-23-2013 01:31 PM

replcaing motherboard and keep array in place

I've been asked to replace the motherboard in one of our servers. The controller currently installed in the server is a Smart Array E200 configured for RAID 5. The array should not need any special configuration on the new motherboard should it? As for as I can forsee I just need to install it and set it as the boot device. Am I wrong?

0 Kudos
Reply
1 REPLY 1
Jimmy Vance
HPE Pro

‎11-24-2013 04:22 PM

‎11-24-2013 04:22 PM

Re: replcaing motherboard and keep array in place

The RAID configuration information for the array is stored on each disk. You will not loose the array information changing out a defective system board

 

 

No support by private messages. Please ask the forum! 
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.