ProLiant Servers - Netservers
Showing results for 
Search instead for 
Do you mean 

how to check if we had install the BBWC in linux?

Occasional Contributor

how to check if we had install the BBWC in linux?

Dear all,
I use following command to check,

cd /opt/compaq/hpacucli/bld/
./hpacucli

ctrl all show status

ctrl slot=? show

But, what's the keyword in output for BBWC?
please ref attached file.


1 REPLIES
Highlighted
Honored Contributor Honored Contributor

Re: how to check if we had install the BBWC in linux?

Hi Romeo,

looks like you don't have the BBWC, look at this output. Your Battery pack count = 0.
Don't think there is a separate option/keyword to ACU CLI just retrieve that piece if information only.


HTH

Kris


=> ctrl slot=0 show

Smart Array P400 in Slot 0 (Embedded)
Bus Interface: PCI
Slot: 0
Cache Serial Number: PA82C0J9SWB3VJ
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Chassis Slot:
Hardware Revision: Rev E
Firmware Version: 5.26
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 15 secs
Post Prompt Timeout: 0 secs
Cache Board Present: True
Cache Status: OK
Accelerator Ratio: 25% Read / 75% Write
Drive Write Cache: Disabled
Total Cache Size: 256 MB
No-Battery Write Cache: Disabled
Cache Backup Power Source: Batteries
Battery/Capacitor Count: 1
Battery/Capacitor Status: OK
SATA NCQ Supported: True