HPE Community
MSA Storage
1752317 Members
6235 Online
108786 Solutions
New Discussion

Re: P2000 coad load failure after firmwarer upgraded

 
jomwc
New Member

‎01-10-2016 11:09 PM

‎01-10-2016 11:09 PM

P2000 coad load failure after firmwarer upgraded

i Just updated firmware of P2000 but i got failure as below

Code load failure
starting message server
STATUS : Code Load Failure

the application is not able to communicate with the
storage controller. Verify the storage controller on this
FRU is operating correctly, then retry your request.

This management controller will now reboot.

appsv down

0 Kudos
Reply
1 REPLY 1
giladzzz
Honored Contributor

‎01-11-2016 12:15 AM

‎01-11-2016 12:15 AM

Re: P2000 coad load failure after firmwarer upgraded

Hi

If you did the upgrade from the smart component it need to have access

to both controllers check if you can ping both controllers.

Regards

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.