MSA2000 Management IP change

[Koray Ersin]

Hi,

I just changed the Management IP (set to static IP) of my MSA2000 via the web interface. After 15 seconds, web interface did not come up with the new IP.

Do I need to restart the MSA2000 in order to access the web page with the new IP?

Regards,

Koray

[marsh_1]

from the msa2000fc user guide :-

In the host computer's command window, type the following command to verify
Ethernet connectivity, first for controller A and then for controller B:

ping ip-address

If you cannot your access your system for at least three minutes after changing
the IP address, your network might require you to restart the management
controller using the serial CLI. When you restart a management controller,
communication with it is temporarily lost until it successfully restarts.
Type the following command to restart the management controller on both
controllers:

restart mc both


HTH

[Arian van der Pijl]

If you have a dual controller msa 2000 then I would change one controller at a time.
Regards,
Arian van der Pijl

[Koray Ersin]

Thanks for the answers,

Koray