SNMP IP range

[gabbar]

I am trying to add IPs in SNMP ACL.. but webtools only gives me an option to enter 6 IPs. Is it possible to add more?

[Taifur]

Hi Rahul,

For details SAN configuratiom you can check the below link,

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?contentType=SupportManual&locale=en_US&docIndexId=179911&taskId=101&prodTypeId=12169&prodSeriesId=406734

Rgds//
Taifur

[gabbar]

thnx but that does not help much

[Rob Leadbeater]

Hi,

> thnx but that does not help much

Neither does your question...!

Letting people know what product you are using would be a good start.

Cheers,

Rob

[gabbar]

since i am refering to webtools, its quite obvious it is a brocade switch. Firmware is 5.3.0d.

[marsh_1 · Accepted solution]

hi,

AFAIK this is not possible , the agent only supports 6 entries.

HTH

[Mark Poeschl_2]

I specify xxx.yyy.zzz.0 for my address and it appears to cover the whole subnet. In fact from the CLI the entry shows up as:

Entry 0: Access host subnet area xxx.yyy.zzz.0 (rw)

so it's pretty clear Brocade intends these top be subnet, not host addresses. Don't know if this will help you or not...

[gabbar]

i agree with Mark Hunt. it is simply not possible to add more than 6 entries.

[Mark Poeschl_2]

I agree about six entries, but each entry could be an arbitrarily large subnet.