Switches, Hubs, and Modems
1747980 Members
3871 Online
108756 Solutions
New Discussion юеВ

HP Procurve 2810 - Multicast/Microsoft NLB

 
Sudipta Paul
New Member

HP Procurve 2810 - Multicast/Microsoft NLB

One of my customer is using HP Procurve 2810 and he wants to configure Microsoft NLB. For this he wants to configure static Multicast MAC address in the switch's CAM table so that it knows how to switch multicast traffic appropriately instead of flooding. How can we do it ?

There is one command called static-mac used for MAC lockdown. Can we use the multicast address in the command ? And can we use two interfaces in this command if we use multicast MAC address. Or else how can I do that.

In other words is there any similar command in Procurve of the below which is in Cisco.

mac-address-table static 0100.5e7f.3359 vlan 51 interface GigabitEthernet2/0/5 GigabitEthernet1/0/5
3 REPLIES 3
Pieter 't Hart
Honored Contributor

Re: HP Procurve 2810 - Multicast/Microsoft NLB

read : http://technet.microsoft.com/en-us/library/bb742455.aspx

read carefully the unicast and multicast sections.

microsoft advices to use a seperate vlan,
containing only the hosts from the NLB, so flooding is only within this vlan!
Evert Goor
Trusted Contributor

Re: HP Procurve 2810 - Multicast/Microsoft NLB

HP Procurve is not supporting static arps.
Dinko Fabri─Нni
New Member

Re: HP Procurve 2810 - Multicast/Microsoft NLB

Hi,

I have some info about HP Procurve 5300 switches regarding Microsoft multicast NLB. It works without entering static ARPs. More info here: http://solutiondumps.blogspot.com/2011/01/microsoft-nlb-and-hp-procurve-switches.html

Dinko