CLI in 3Com Baseline Switch 2952-SFP

[Iroal]

Hi,

I've just installed a new 3Com Baseline Switch 2952-SFP and I don't know how to access to all functionality via TELNET, I access with management access level.

I've just access only to this commands:

 initialize 
 ipsetup    
 password   
 ping       
 quit       
 reboot     
 summary    
 upgrade   

How can I access to all the commands?

I want to create a Vlan using IP subnet and I cannot do it using Web interface.

Thanks.

Regards

[mbrownnyc]

at 3COM CLI

_cmdline-mode on

[password is] 512900

sys [to elevate to configuration prompt]

I started manually enumerating the command tree.  See attached.

[mbrownnyc]

Wow.  I think I just found a goldmine:

I'm very giddy right now: 

The H3C S5500-52C-PWR-EI looks quite familiar, ey?

http://www.h3c.com/portal/Technical_Support___Documents/Technical_Documents/Switches/H3C_S5500_Series_Switches/#Command

[edit]

looks like I could be a little off with the model number, -EI switches support IPv6, and -SI switches don't.  This seems to be the difference.