HPE Community
Switches, Hubs, and Modems
1752519 Members
4951 Online
108788 Solutions
New Discussion

IP multicast routing between two VLANs on ProCurve 2910

 
SOLVED
Go to solution
Mutex
Occasional Advisor

‎12-14-2010 02:17 AM

‎12-14-2010 02:17 AM

IP multicast routing between two VLANs on ProCurve 2910

Hello!

Is it possible to pass a multicast stream from one VLAN into another VLAN without a dedicated multicast router? Is the ProCurve 2910 capable of any multicast routing? Does the 2910 support PIM-SM (Protocol independent multicast sparse mode).

Regards Mutex
0 Kudos
1 REPLY 1
Helper
Valued Contributor

‎12-14-2010 05:01 AM

‎12-14-2010 05:01 AM

Solution

Re: IP multicast routing between two VLANs on ProCurve 2910

Hi,

2910 only support multicast at layer2 level. So the traffic will not past from one vlan to another.

Bye.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.