How to use iso9600 image file on HP-UX 11i

[Zuojian]

How to use iso9600 image file(.iso file) on HP-UX 11i,thanks

[Kent Ostby]

This thread discusses how to do it on a 10.20 system. Not sure if you would use the same steps, but its a starting point:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=104236

[H.Merijn Brand (procura]

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=938988

is that what you want? I mean, do you have the same question?
Your question is too vague for me

Enjoy, Have FUN! H.Merijn

[Zuojian]

I mean,I have a ISO fileâ â software.iso,how to mount on mount-point /testdir ?
Thanks

[H.Merijn Brand (procura]

You can't (yet) on HP-UX.
Sorry.

Burn is on CD and *then* you can mount.
HP-UX's mount command only supports devices, not files, and the loopback device cannot be used

Enjoy, Have FUN! H.Merijn

[Alzhy]

If you're used to loopback filesystems that support isofs (i.e. on Linux and Solaris), then you're out of luck. I've been asking this question (and I think I may have submitted an RFE/RFC) for about 3 years now.

Your best bet is just mount on Linux/Solaris and NFS share to HP-UX.