HPE Community
Operating System - HP-UX
1752810 Members
6248 Online
108789 Solutions
New Discussion юеВ

lvlnboot - any way to remove a dump area

 
SOLVED
Go to solution
S.Rider
Regular Advisor

тАО08-18-2005 04:27 AM

тАО08-18-2005 04:27 AM

lvlnboot - any way to remove a dump area

My boot disk shows lvol2 (primary swap) as dump in addition to lv_dump1 & lv_dump2 which we created. I don't see an option in the lvlnboot command to remove a dump area, is there any way to remove lvol2 as the dump area. I still want to retain lvol2 for swap.
Ride Boldly Ride, but watch out for El Dorado's
0 Kudos
Reply
2 REPLIES 2
RAC_1
Honored Contributor

тАО08-18-2005 04:33 AM

тАО08-18-2005 04:33 AM

Solution

Re: lvlnboot - any way to remove a dump area

Check the lvrmboot command. First you need to reove it using lvrmboot and then use new dump lvols. Define new dump lvols with lvlnboot

Anil
There is no substitute to HARDWORK
Reply
S.Rider
Regular Advisor

тАО08-18-2005 05:00 AM

тАО08-18-2005 05:00 AM

Re: lvlnboot - any way to remove a dump area

yup, lvrmboot did it. I was gonna complain that the lvrmboot command wasn't listed at the bottom of the "man lvlnboot" but it was and my tired eyes had skipped over it.
Ride Boldly Ride, but watch out for El Dorado's
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.