- Community Home
- >
- Servers and Operating Systems
- >
- Operating Systems
- >
- Operating System - OpenVMS
- >
- Re: Integrity BL860c I2 monitoring P410i
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2013 09:00 AM
10-25-2013 09:00 AM
Integrity BL860c I2 monitoring P410i
Folks,
I'm building the above box with an embedded P410i talking to a D2200sb storage blade. Array controller is in RAID mode.
All is working nicely, System Management Homepage, WBEM, SNMP etc. However, when I simulate a drive failure in the D2200sb by pulling a drive the controller will correctly start rebuilding on the hot spare, MSA$UTIL shows the rebuild and that a drive's been pulled..... but nothing tells the management utilities and VMS doesn't log any errors. When the rebuild completes I replace the pulled drive and the controller rebuilds onto that, returning the hot spare.
Anyone know what actually logs these errors?
Cheers
Adrian
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-15-2013 01:51 PM
11-15-2013 01:51 PM
Re: Integrity BL860c I2 monitoring P410i
Do you have WEBES or SMH installed?
Check both of these and see if it is there or in the errlog file.