HPE Community
StoreEver Tape Storage
1753370 Members
5154 Online
108792 Solutions
New Discussion

Re: Firmware Colorado 20Gb

 
SOLVED
Go to solution
CA845097
Occasional Advisor

‎09-21-2002 06:41 PM

‎09-21-2002 06:41 PM

Re: Firmware Colorado 20Gb

Folks:
I am having the same problem (need to update my firmware), but I have the additional problem that WinXP sees the tape drive in device manager, but does not show it using resources (ie IRQ or I/O address), so I cannot get the DOS boot disk to work. Any ideas on how to get the IRQ and I/O the drive is using? The tape is the secondary IDE slave device, if that helps.
0 Kudos
Reply
CA845097
Occasional Advisor

‎09-21-2002 08:07 PM

‎09-21-2002 08:07 PM

Re: Firmware Colorado 20Gb

Folks:
I figured out the DOS firmware problem, my device is on the primary IDE chain, so I just had to change the address and IRQ in the .ini file to get it to work. I flashed the firmware, but I still get the same error message - 05-0E-23-01-0524, when I try to use Backup MyPC or Colorado b/u v9.1. This is supposed to be a firmware problem, but I have the latest f/w. Any ideas? Thanks in advance.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.