HP 9322 Library

[mrArcadian]

Having a major issues

Error

4

85

20

Horiz: axis not found

Encoder did not showed being moving at time of intialization.

Replaced encoder on both motors, replace mother board, replace all boards.

Y axis and X axis boards, Still gives the same error.

There is a flag on the bottom but do not know if its just that.

When i run the command to calibrate give error that Axis did not find home.

Nothing is blockling the way of either axis, runs smooth. no obstruction or anything.

checked all belts and still nothing even change the red motor its has.

I dont know what to do anymore.

thanks for any helps

P.S. This thread has been moved from Storage Area Networks (SAN) (Enterprise) to Tape Libraries and Drives. -HP Forum Moderator