- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- ghost LTO5 drive in MSL8048
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-09-2013 05:34 AM
01-09-2013 05:34 AM
ghost LTO5 drive in MSL8048
Hello
I have installed an MSL8048 library with 2 LTO5 drives (half height). I first put the drives in slot 1 & 2, but later I found I needed to parition the library and then I had to move the drive from slot 2 to slot 3 to be able to parition it. Since then, I see 3 drives in the web interface : drive 1 & 3 : my 2 LTO drives, drive 2 : <red cross> drive removed (see attached screensot)
This is not a big issue, but in my backup software (Backup Exec) I get the same behaviour : in the first virtual library, I can see 2 drives, one of them being "offline".
Is there anyway to "reset" the library so that I only see the actual situation ?
Thanks in advance for any help