- Community Home
- >
- Networking
- >
- Legacy
- >
- IP Telephony - VCX
- >
- FXO inbound calls do not work
IP Telephony - VCX
1756746
Members
3225
Online
108852
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-14-2009 06:34 PM
01-14-2009 06:34 PM
FXO inbound calls do not work
I've setup a 4 port fxo gateway, outbound calling works fine, when a call comes inbound from the PSTN it will ring once and then the caller hears dial tone, the call never connects and eventually the line goes dead.
After some playing around and testing I found that if I enter a extension number when I hear the dial tone after the ring the call will eventually connect.
I'm sure I've missed something in the configuration but can not spot what it is, would someone be so kind as to point out what I am missing?
Cheers, Soxcamp
After some playing around and testing I found that if I enter a extension number when I hear the dial tone after the ring the call will eventually connect.
I'm sure I've missed something in the configuration but can not spot what it is, would someone be so kind as to point out what I am missing?
Cheers, Soxcamp
Cheers, Soxcamp
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-14-2009 08:00 PM
01-14-2009 08:00 PM
Re: FXO inbound calls do not work
G'day Soxcamp you need to configure automatic dialing for each fxo port. To do this log onto your gateway, select Protocol Management -> endpoint settings -> Automatic dailing. Enter the destination extension you wish for all calls that come in on that fxo port to goto. Make sure that the auto dial status is set to enable.
Hope this helps
Hope this helps
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP