Showing results for 
Search instead for 
Do you mean 

Remove vPar Error

Occasional Contributor

Remove vPar Error

How can I remove a vPar?

I have a nPar with 2 vPars:
vPar1 = 11.23
vPar2 = 11.31

I have to remove the vPar2 but I get the following error:
# parremove –p vPar2

vparremove: Error: Command version 1.4 is incompatible with monitor version 1.50

How can I remove this vPar???

cdiasan
3 REPLIES
Acclaimed Contributor Acclaimed Contributor

Re: Remove vPar Error

[ Edited ]

You need to try this with the 11.31 command set, the 11.23 command set cannot do this.

 

After this you need to boot the vpmon from the 11.23 partition.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Occasional Contributor

Re: Remove vPar Error

Do not understand what you explain more.
How do I delete a partition from which I located and is active??.

vpar2 # vparremove-p vpar2 (this can be done).

How do I boot from vpar1 vpmon (11.23)?

 

Regards

cdiasan
Acclaimed Contributor Acclaimed Contributor

Re: Remove vPar Error

IMHO you have 2 options:

 

1) boot from the 11.23 vpmon and try from there (reboot system and boot from the 11.23 boot disk /stand/vpmon)

 

2) boot 11.31 in nPar mode and remove the vPar.

 

 

I'm not sure if the 11.23 vpmon can use the vpdb created with the 11.31 version. If not, consider to re-create the 11.23 vPar using the 11.23 command set.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!