- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- WAN Routing
- >
- WAN Interfaces config on MSR920
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2015 12:16 PM
03-15-2015 12:16 PM
WAN Interfaces config on MSR920
Hello all!
I have a H3C MSR920 router and it is working fine - but there is a rob - I have two IP from my provider and I want to set it up so, that on Ethernet0 there is IP one and on Ethernet1 the second one; I would then route manually traffic trough - no balancing or sharing whatsoever. Anyway when I try to setup the second IP on the second WAN interface I always get error "Error: The IP address you entered overlaps with another interface!" - the IPs are not the same but they are from the same range (eg. 100.100.1.2 and 100.100.1.8) - how can I go about this? I would really like to utialize both of them.
Thank you all in advance!
RGD