HPE Community
Web and Unmanaged
1753448 Members
6580 Online
108794 Solutions
New Discussion

Configuring V1910-48g

 
wowmejames
New Member

‎11-05-2012 06:46 AM - last edited on ‎08-25-2013 08:58 PM by

‎11-05-2012 06:46 AM - last edited on ‎08-25-2013 08:58 PM by

Configuring V1910-48g

Hi

I am a trying to find out if it is possible to configure an HP V1910-48g so that 802.3ad Link Aggregation is enabled on a couple of ports. I have a Mac Server with two NIC's (which are bonded together) and they were previously connected to a ProCurve 1800 in ports 1 & 2. all worked fine until I connected them up to a new switch and I get a message on the Mac saying that I need to enable 802.3ad Link Aggregation on these ports. Can anyone help?

I am running complete Mac network but might be able to get a MS laptop if needed to help configure.

 

Any pointers would be much appreciated.

 

 

P.S. This thread has been moved from Network Management > PCM to Web and Unmanaged. - Hp Forum Moderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.