- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Web and Unmanaged
- >
- HP 1920-48 - WebLogin address(es)
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-27-2015 12:38 PM
10-27-2015 12:38 PM
HP 1920-48 - WebLogin address(es)
Hi folks,
I'm new to this forum and HP's 1920 switching technology.
What I'd like to do is getting a 1920 configured with 2 VLANs (intranet and adminnet), but with WebLoing enaböed in only one (adminnet) of them.
So far I configured the 1920 with two port based VLANs and assigned one static adddress to each.
I'm performing the routing between these two VLANs by a seperate firewall which works fine for me.
My problem this in the Web GUI's wizzard in the "Management IP Interface Configure" I can configure one IP address for each VLAN. But, when I changethe "Admin Status" from "Up" to "Down it works for both interfaces instead of just one and I kicked out myself from the WebGUI. How can I get this configuration running using just one of these Management IP Interfaces?
I tried to revoke/change my selection via serial console, "_cmdline-mode on" and "SYS". There are a lot of CLI commands available, but sadly not documentation available on the web. Searched 4 hours now using Google and gave up. Just old ProCurve CLI documentations are available, using "enable" and "config" mode (I know form former times ... and from CISCO routers).
But, back to my inital question: How can I configure the 1920 for 2 port based VLANs using only interface in one VLAN for WebLogin?
Any ideas, hints, etc.?
Thanks in advance and greetinx
priesemut
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2015 11:36 PM
11-04-2015 11:36 PM
Re: HP 1920-48 - WebLogin address(es)
If you don't need routing, just create the 2 required VLANs, but only 1 VLAN interface.
Alternatively, under Security, Authorized IP, you can apply access list of source addresses allowed to connect to web gui