HPE Community
Web and Unmanaged
1753925 Members
8650 Online
108810 Solutions
New Discussion

Re: Link Aggregation on HP V1910 24Port POE Switch

 
Mohanreddy4u
Occasional Visitor

‎04-28-2014 07:24 PM - last edited on ‎04-29-2014 08:39 PM by

‎04-28-2014 07:24 PM - last edited on ‎04-29-2014 08:39 PM by

Link Aggregation on HP V1910 24Port POE Switch

Hi 

How do i enable link aggregation on HP V1910 POE Switch.

 

is there any step by step instructions?

 

Thanks and Regards

Mohan

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to  Web and Unmanaged. -HP Forum Moderator

0 Kudos
1 REPLY 1
hansvb
Frequent Advisor

‎04-29-2014 12:45 AM

‎04-29-2014 12:45 AM

Re: Link Aggregation on HP V1910 24Port POE Switch

The aggregation group configuration procedure is as follows:

l Static aggregation mode

#

interface Bridge-Aggregation1

#

interface GigabitEthernet1/0/1

port link-aggregation group 1

#

interface GigabitEthernet1/0/2

port link-aggregation group 1

#

interface GigabitEthernet1/0/3

port link-aggregation group 1

#
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.