2626 J4900b Reset no response

[lateralhadley]

Hi all,

I've just reset my Procurve 2626 J4900b and now I can't get anything out of it?

It reboots fine, and the lights indicate it's going through it's POST cycle, but after that, I've got no management interfaces?

I held down the RESET + CLEAR buttons as per the manual and then released the CLEAR as the Self Test started blinking. That caused it to do the reset and POST... but now I can't get any management info out of it?

I've tried connecting to the Console, nothing?!

I've tested that cable on another switch and it's fine.

9600, 8 data, 1 stop, no parity, Xon/Xoff 

I've looked in the manual and even tried the Upload firmware steps if corruption is suspected. (no flow control)

I can't work out what is going on? 

Would the Management Web interface be up? 

If so, what is the default IP address of the switch post config reset?