- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Virtual Connect hostname
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-16-2015 08:21 AM
01-16-2015 08:21 AM
Virtual Connect hostname
Hi!
I need evidence of the Virtual Connect hostname and IP address. When I got this screenshot the hostname is not shown. Maybe it was never setup. If that is the case how can I setup the hostname for the Virtual Connect or where I can grb a screenshot showing both the hostname and IP address.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-19-2015 01:33 AM - edited 01-19-2015 01:38 AM
01-19-2015 01:33 AM - edited 01-19-2015 01:38 AM
Re: Virtual Connect hostname
Greetings,
You may change the VC hostname from VCM(Vitual Connect Manager).
1. In VCM, select the hardware.
2. Click on Interconnect bays.
3. Select the Switch.
4. Click on Module Host Name.
You will have an option to reset the module name.
Check out the screen shot attached.
The options listed will change depending on the firmware versions installed.
Please give this a try and let me know the status.
I hope the info will help you.
Regards,
Renji V
Was this post useful? -
To say thanks click the "thumbs up" icon below!!! .....
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-19-2015 10:52 AM
01-19-2015 10:52 AM
Re: Virtual Connect hostname
I did that but still (on the screen that I included) does not show the hostname. I am assuming that hostname equals user assigned name. If that is not the case, then how can I assign the user assigned name. I need to capture a screen that includes the hostname and the IP.
Thanks!