View ACL denty logs

[KennyP]

I have a 10504 running Comware 5 release 1208p12-US.

I've been racking my brain trying to figure out the command to view detail information about what is being blocked by an ACL...Like in Cisco it would tell that this ACL block this IP trying to connect to this address in the log, but HP this is not there. Is there a way to view a deny log at all in HP comware...Most of my coworkers are saying this is not possible, but I don't believe this is true.

 Here's my ACL:
ACL's step is 5
 rule 5 permit ip source X.X..20.0 0.0.0.255
 rule 7 permit ip source X.X..8.27 0
 rule 8 permit ip source X.X..8.28 0
 rule 9 permit ip source X.X..8.29 0
 rule 10 permit ip source X.X..42.0 0.0.0.255
 rule 11 permit ip source X.X..115.228 0.0.0.3
 rule 14 permit ip source X.X..199.57 0
 rule 15 permit udp source X.X..85.7 0 source-port eq ntp
 rule 16 permit ip source X.X..200.0 0.0.0.255
 rule 17 permit ip source X.X..199.0 0.0.0.255
 rule 18 permit ip source X.X..185.224 0.0.0.3
 rule 19 permit ip source X.X..192.0 0.0.0.255
 rule 20 permit ip source X.X..9.126 0
 rule 25 permit ip source X.X..58.0 0.0.0.255
 rule 30 permit ip source X.X..147.0 0.0.0.255
 rule 35 permit ip source X.X..152.0 0.0.0.255
 rule 40 permit ip source 192.168.0.0 0.0.255.255
 rule 41 permit ip source X.X..17.0 0.0.0.255
 rule 42 permit ip source X.X.0.0 0.0.255.255 logging
 rule 43 permit ip source X.X.0.0 0.0.255.255 logging
 rule 45 deny ip logging (661 times matched) <-----trying to see what is being Blocked here.

Thanks for the help!!!