Trusted Contributor
Re: Adding topology with command loadhosts but return object is unknown

Hello.

Please, check out the KCS doco http://support.openview.hp.com/selfsolve/document/KM109050.

 

You need to supply correct mask with loadhosts command. Like:

 

loadhosts -v -m <netmask> -c <IP address> -n 1

 

And also netmon should be stopped before you use loadhosts. So, preferred is using "netmon -h <IP>" if you run NNM 7.53.

To make use of this command, netmon auto-discovery has to be tuned on.

Mikayel Grigoryan
HPE Software

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.