Hewlett Packard Enterprise Community
Showing results for 
Search instead for 
Do you mean 
When configuring any device, there is a box you can check 'MultiPath'.  When you activate this func...
by on ‎05-14-2015 08:56 AM
1 Reply 359 Views
1 Reply
359 Views
The most common reason for this error is that your system contains a drive without a designated dri...
by on ‎04-29-2015 02:45 PM
7 Replies 638 Views
7 Replies
638 Views
You need to know one of the following      - Media :Label    - Barcode Label (if available)    ...
by on ‎04-29-2015 02:35 PM
0 Replies 180 Views
0 Replies
180 Views
You will probably need a Windows system to run your GUI inside your domain
by on ‎04-29-2015 09:04 AM
0 Replies 2338 Views
0 Replies
2338 Views
The error   [12:1625] Import host failed.   is almost always a hostname resolution problem. ...
by on ‎04-28-2015 12:22 PM
1 Reply 505 Views
1 Reply
505 Views
I don't think that the error   Cannot write [1336] The access control list (ACL) structure is in...
by on ‎04-28-2015 12:19 PM
2 Replies 254 Views
2 Replies
254 Views
  Here is quote from documentation: “1.1.1.1 Remote PowerShell Configuration Privileges ... By d...
by on ‎04-28-2015 12:12 PM
2 Replies 261 Views
2 Replies
261 Views
Without any additional information, it is difficult to asses what the probem is, but, to directly a...
by on ‎04-24-2015 08:15 AM
1 Reply 260 Views
1 Reply
260 Views
Do NOT install these patches.  My recommendation was based on this in your Forum thread title   A...
by on ‎04-24-2015 05:50 AM
1 Reply 231 Views
1 Reply
231 Views
I checked lab cases for this error, found two, neither of which provided an actual solution.   Lo...
by on ‎04-23-2015 07:28 AM
3 Replies 276 Views
3 Replies
276 Views
Be careful about the use of 'NoTreewalk', it may not allow you to do Incremental Backups
by on ‎04-22-2015 10:58 AM
1 Reply 432 Views
1 Reply
432 Views
Not quite sure what you mean by 'QuickSpecs'.  I think you may find this in the Installation and Li...
by on ‎04-22-2015 10:56 AM
0 Replies 6733 Views
0 Replies
6733 Views
My first suggestion would be to do a Verify on the tape.  It takes 2-3 hours to Verify a LTO-4 tape...
by on ‎04-15-2015 09:54 AM
0 Replies 344 Views
0 Replies
344 Views
Go to Devices and Media, expand your tape library,expand Drives, right click on the drive in questi...
by on ‎04-15-2015 09:40 AM
0 Replies 380 Views
0 Replies
380 Views
While I dodn't see anything that prohibits this, I don't understand why you would want to do this ...
by on ‎04-14-2015 07:04 AM
3 Replies 271 Views
3 Replies
271 Views
"Is their a possibility to get the name of the databases with a command "   No, you would have to...
by on ‎04-14-2015 06:50 AM
4 Replies 370 Views
4 Replies
370 Views
My advice is to install DP 6.2 on your new host, make sure it is up and running, restore the IDB an...
by on ‎04-13-2015 08:05 AM
0 Replies 313 Views
0 Replies
313 Views
You were actually pretty close, try         omnirpt -report dl_info -tab   Shows information ab...
by on ‎04-13-2015 08:01 AM
6 Replies 404 Views
6 Replies
404 Views
How did you set OB2IPCKEEPALIVE?  Assuming this is emulating a Windows server, you need to add thes...
by on ‎04-09-2015 09:56 AM
0 Replies 194 Views
0 Replies
194 Views
If I understand your question correctly, you can issue any command with the '-ver' argument.  For e...
by on ‎04-09-2015 07:19 AM
0 Replies 224 Views
0 Replies
224 Views