Hewlett Packard Enterprise Community
Showing results for 
Search instead for 
Do you mean 
So, where are your snapshots of the statistics such as netstat, ethtool and/or switch stats?
by Honored Contributor on ‎06-14-2011 11:01 AM
0 Replies 798 Views
0 Replies
798 Views
So with regards to: 1) - a new TCP connection for each transaction is a model that went-out with ...
by Honored Contributor on ‎06-10-2011 09:26 AM
0 Replies 798 Views
0 Replies
798 Views
Is this "600 concurrent TCP traffic" 600 different connections, or 600 messages on one TCP connectio...
by Honored Contributor on ‎06-09-2011 09:00 AM
0 Replies 798 Views
0 Replies
798 Views
Not much to add but this - if the application is written "correctly" the only thing standing in the ...
by Honored Contributor on ‎06-03-2011 05:35 PM
0 Replies 3195 Views
0 Replies
3195 Views
You want to look at the writeups for Auto Port Aggregation. That is what HP-UX calls NIC teaming/bo...
by Honored Contributor on ‎06-03-2011 05:31 PM
0 Replies 2457 Views
0 Replies
2457 Views
To expand a bit on what Dennis said lest it run afoul of the telephone game, apart from on a few PA-...
by Honored Contributor on ‎05-31-2011 09:56 AM
0 Replies 1252 Views
0 Replies
1252 Views
Take a tusc trace to see what system calls the svc_sendreply() is making, and do the same on the 11....
by Honored Contributor on ‎05-26-2011 05:22 PM
0 Replies 148 Views
0 Replies
148 Views
Probably. There was a minimum RHEL5 "dot rev" required for the BL460c G6's with the Flex 10 LOM. Y...
by Honored Contributor on ‎05-25-2011 05:40 PM
0 Replies 666 Views
0 Replies
666 Views
Matti is correct - vestiges of LLA remained in 11.11 at the request of the workstations group even a...
by Honored Contributor on ‎05-25-2011 05:38 PM
0 Replies 355 Views
0 Replies
355 Views
FWIW, /sbin/init.d/xntpd is not a binary, it is a startup script. So, when you copied it from one s...
by Honored Contributor on ‎05-17-2011 04:18 PM
0 Replies 565 Views
0 Replies
565 Views
There is a very important note in the quickspecs: "NOTE: PCI-X support is limited to PCI-X cards ...
by Honored Contributor on ‎05-17-2011 10:25 AM
0 Replies 801 Views
0 Replies
801 Views
Terminology nit - I suspect the badly broken software you mention needs the clock to be "behind" not...
by Honored Contributor on ‎05-17-2011 10:21 AM
0 Replies 565 Views
0 Replies
565 Views
If you are looking to have the system stand-in for a BL860c, an rx2800 i2 rack-mount should be quite...
by Honored Contributor on ‎05-13-2011 05:20 PM
0 Replies 149 Views
0 Replies
149 Views
Based on http://h18004.www1.hp.com/products/servers/linux/supportmatrix/rhel/exceptions/rhel-excepti...
by Honored Contributor on ‎05-13-2011 05:16 PM
0 Replies 586 Views
0 Replies
586 Views
In the vein of "Don't raise the bridge, lower the river" might there be a PCIe version of the card y...
by Honored Contributor on ‎05-13-2011 06:14 AM
0 Replies 3199 Views
0 Replies
3199 Views
Well, one *can* run a PA-RISC binary on an Integrity system via ARIES emulation, but indeed it is be...
by Honored Contributor on ‎05-12-2011 08:08 AM
0 Replies 1675 Views
0 Replies
1675 Views
With what are you measuring throughput? 2 Gbps sounds like a single-stream throughput test. The ...
by Honored Contributor on ‎05-11-2011 08:07 AM
0 Replies 507 Views
0 Replies
507 Views
Perhaps something to do with HBA vs RAID mode and a need to run saupdate? This: http://bizsuppor...
by Honored Contributor on ‎04-27-2011 08:44 AM
0 Replies 631 Views
0 Replies
631 Views
If this is for internal drives, you need/want the rx2660 P400i bundle with the card to enable the mo...
by Honored Contributor on ‎04-22-2011 08:47 AM
0 Replies 631 Views
0 Replies
631 Views
Yes, the 6120 should work with the same set of interfaces as a Flex-10 module. Just without the VC ...
by Honored Contributor on ‎04-21-2011 09:12 AM
0 Replies 663 Views
0 Replies
663 Views