Disk fail HPE Smart Array E208i-p SR Gen10

[Skoud]

Hi everyone

I have a Microserver GEN10+ which was working perfectly since december, the FS turned into RO mode and after a reboot, the RAID failed.

I bought two new SSD disks, deleted the RAID1 array and made a new one. It worked perfectly during about 1 to 2 hours but then one of the drives failed and 30min later, the second one failed too.

I re-created the array with the same disks, and I got exactly the same issue.

SMART tests are ok. I updated the e208i-p firmware, with no change, then tried to downgrade it (it's currently running in v5).

I have another RAID array which has no issue

Do you guys have any idea to fix this ?

[TVVJ]

Hello, 

If there known working hard drive spares, install them to isolate between the hard drives and the connectors.

Regards,