HPE Community
Disk Enclosures
1753925 Members
8986 Online
108810 Solutions
New Discussion

Who Me Too'd this topic

Phil D Jones
Occasional Contributor

‎11-02-2010 10:13 AM

‎11-02-2010 10:13 AM

Pairdisplay intermittent

Hi all, I have HORCM installed on 2 Windows 2008 servers.It is a Veritas Metrocluster. I have a situation where when I open a cmd prompt on both servers,and run pairdisplay, the first one I run it on times out with this error...

C:\HORCM\etc>pairdisplay -g BCDR_CA -I50
pairdisplay: [EX_ENORMT] No remote host alive for remote commands or Remote Raid
Manager might be blocked (sleeping) on an existing I/O.
Refer to the command log(C:\HORCM\log50\horcc_G4W2878C_log.txt) for details.

Then I run it on the other one and it works, but then it all of a sudden works on the other... this works this way going both directions... then I let it sit for a couple of minutes, then it does not work again... I tried adjusting the timeout in the HORCM.conf file....I have checked the network... there are no firewalls and all looks good. Is there some setting that will set a "keep alive" value where they do not "sleep"
1 person had this problem.
0 Kudos
Reply
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.