- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Servers - General
- >
- DL580G5 doesn't boot
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2023 09:36 AM - last edited on 04-18-2023 06:36 PM by support_s
04-06-2023 09:36 AM - last edited on 04-18-2023 06:36 PM by support_s
DL580G5 doesn't boot
Hi, this is my error led https://pasteboard.co/UuvfduLnmMa9.jpg
All my memory banks are corrupted?
Is it possible?
How can I troubleshoote?
Thank you
- Tags:
- Prolaint server
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-10-2023 06:24 AM
04-10-2023 06:24 AM
Re: DL580G5 doesn't boot
Hello,
You may try clearing the server's NVRAM.
- For this power off the server and remove the power cable from the power supplies.
- Remove the access panel and identify the system maintenance switch.
- You may refer to section "Server component identification > System maintenance switch (SW1)" on page 74 of the HPE ProLiant DL580 G5 Server's maintenance and server guide for identifying the system maintenance switch.
- Once identified, set the switch 'S6' from the default position of 'Off' to 'On' and then power on the server.
- Once you see the message that one or more of the system maintenance switch is turned and revert its position to default, then power off the server, remove the power cables and reverse the switch S6's position to Off.
- Power on the server and check if the issue is resolved. If the issue is resolved, then re-enter the server serial number and product ID in the server's BIOS. You may refer to page 57 of the above mentioned guide.
Regards,
Views expressed herein are my personal opinion and are not the views of HPE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-18-2023 03:24 AM
04-18-2023 03:24 AM
Re: DL580G5 doesn't boot
Greetings!
Please advise if any other queries on this.
I am an HPE employee.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]