Posted to: MSA Storage
yesterday Hi all, this is the problem of iscsi connections between the storage and the server, but there's no attached volume, Please tell me the correct way to grant access on the storage side, if you could elaborate on the instructions, thank yousupplements... Posted to: ProLiant Servers (ML,DL,SL)
26m ago Question about DL380Gen11 12EDSFF chassis and EDSSF NVMe drives. There is 12 slots, which controller are the drives connected to? QuickSpec state that DL380 Gen11 12EDSFF NC CTO P52536-B21 have Embedded SW RAID with 14 SATA ports (12-ports accessible... Posted to: ProLiant Servers (ML,DL,SL)
01-03-2024 I recently bought my first Gen11 server - an ML110.I found that fans make more noise if compared to older servers.When server was first started fans 3 and 4 ran at 60-65% for 3-5 minutes every 15-20 minutes.Then, after bios/firmware/drivers upgrades,...
Posted to: ProLiant Servers (ML,DL,SL)
4 weeks ago I see that a new firmware v 3.03 has been released for iLo 5 , The Upgrade Requirement shows as Recommended, however, the tabs show Enhancements: None and Fixes: None. So what exactly is new in version 3.03 that would incentivize its application? Wh... Posted to: ProLiant Servers (ML,DL,SL)
Monday Hello everyone,I have a strange issue with a HPE Proliant ML110 Gen11 Server, running latest Windows Server 2022 bare metal install. The issue is that the highest resolution available on the server is only 1024x768.The server only has a VGA port on t... Posted to: ProLiant Servers (ML,DL,SL)
01-12-2024 Hallo, ich habe seid dem 03.01.2024 auf einigen unserer DL380 Gen10 Servern Probleme den Festplattenstatus der RAID Controller Festplatten via SNMP auszulesen. Der Controller und die ILO liefern die Informationen korrekt aber via SNMP lassen sich kei...
Posted to: Backup & Recovery Service
Friday I have tried with different network segments, different IPs, even with DHCP (it does not take available IP even if I reserve it) the machine starts fine, without problems and shows the IP I need to connect to but it just does not respond. Ping and HT... Posted to: ProLiant Servers (ML,DL,SL)
yesterday I have this problem on my Hp dl380p g8 Server, only one processor is working when I put the 2 together it doesn't work, I've already switched sides and the same thing happens, the processor and memories are working normally, I've done several tests a... Posted to: HPE Ezmeral Software platform
yesterday I am trying to setup Ezmeral Datafabric 7.3 with 1 master and 6 datanodes. Installation is getting failed at 81 percentage in one node with below error. Followed by this node, installation in other nodes are also getting failed. "mapr_logs": "2024-04... Posted to: ProLiant Servers (ML,DL,SL)
yesterday I have a number of Gen10 and Gen11 servers running Server 2022 with S2D configured for HCI. These are Azure Stack Validated nodes. After applying SPP 2024.04.00.00, the SUM report shows the firmware package installed sucessfully, but the S2D drives f...
