root:orasrv02:/> sautil /dev/ciss4 ****************************************************************************** **** **** **** S A U T I L S u p p o r t U t i l i t y **** **** **** **** for the HP SmartArray RAID Controller Family **** **** **** **** version A.02.05 **** **** **** **** (C) Copyright 2003, 2004 Hewlett-Packard Development Company, L.P. **** ****************************************************************************** ---- DRIVER INFORMATION ------------------------------------------------------ Driver State........................ READY ---- CONTROLLER INFORMATION -------------------------------------------------- Controller Product Number........... A9890A Controller Product Name............. HP PCI-X SmartArray 6402 Hardware Path....................... 0/2/1/0/4/0 Serial Number....................... P57820PXQRH2LY Device File......................... /dev/ciss4 Hardware Revision................... 'B' Boot Block Revision................. 3.86 Firmware Revision (running)......... 2.34 Firmware Revision (in ROM).......... 2.34 Firmware Revision (inactive)........ 2.34 # of Logical Drives................. 1 # of Physical Disks Configured...... 2 # of Physical Disks Detected........ 2 Logical Drive Rebuild Priority...... 0 (low) Array Capacity Expansion Priority... 0 (low) Auto-Fail Missing Disks at Boot..... disabled SCSI Transfer Detection Mode........ Auto Detect ---- ARRAY ACCELERATOR (CACHE) INFORMATION ----------------------------------- Array Accelerator Board Present?.... yes Cache Configuration Status.......... cache enabled Cache Ratio......................... 50% Read / 50% Write Total Cache Size (MB)............... 128 Read Cache........................ 064 Write Cache....................... 064 Transfer Buffer................... 000 Battery Pack Count.................. 2 Battery Status (pack #1)............ ok Battery Status (pack #2)............ ok ---- LOGICAL DRIVE SUMMARY --------------------------------------------------- # RAID Size Status 0 1+0 34727 MB OK ---- SCSI DEVICE SUMMARY ----------------------------------------------------- Location Ch ID Type Capacity Status internal 1 0 DISK 36.4 GB OK internal 1 1 DISK 36.4 GB OK ---- SCSI BUS SUMMARY -------------------------------------------------------- External Internal Ch LVD_Mode Connector Connector 1 YES - YES 2 YES - - ---- LOGICAL DRIVE 0 --------------------------------------------------------- Fault Tolerance Mode................ RAID 1+0 (Disk Mirroring) Logical Drive Size.................. 34727 MB Logical Drive Status................ OK # of Participating Physical Disks... 2 Participating Physical Disk(s)...... Ch:ID 1: 0 1: 1 Participating Spare Disk(s)......... Ch:ID none Stripe Size......................... 128 KB Logical Drive Cache Status.......... cache enabled Configuration Signature............. 0xA2705972 Media Exchange Detected?............ no ---- SCSI DEVICE 1:0 [DISK] -------------------------------------------------- Connector Location............................... internal Channel Number................................... 1 SCSI ID.......................................... 0 Device Type...................................... DISK Disk Capacity.................................... 36.4 GB Device Status.................................... OK Device Vendor ID................................. HP 36.4G Device Product ID................................ ST336754LC Device Serial Number............................. 3KQ05TD600007535EZAQ Device Firmware Version.......................... HPC2 SCSI Transfer Rate............................... Ultra-320 Reserved Area (cfg/status info).................. 557.1 KB (0.6 MB) Block Size (bytes/sector)........................ 512 bytes HP Disk Stamped?................................. yes Last Failure Reason.............................. TIMEOUT Physical Disk Flags: Disk present and operational................... yes Non-disk device detected....................... no Wide SCSI transfer enabled..................... yes Synchronous (Fast/Ultra) transfer enabled...... yes Narrow disk tray detected...................... no Wide transfer failed, reverted to narrow....... no Ultra SCSI transfer enabled.................... yes Ultra-2 SCSI transfer enabled.................. yes S.M.A.R.T. supported........................... yes S.M.A.R.T. errors (in factory M&P data)........ no S.M.A.R.T. enabled............................. yes S.M.A.R.T. errors (in powerup M&P data)........ no Attached to external channel................... no Configured in a logical drive.................. yes Configured as a spare disk..................... no Disk write cache enabled at spin up............ no Running in DT clocking mode.................... yes Supports DT clocking mode only................. no Supports DT and ST clocking modes.............. yes Running in U320 mode........................... yes Packetized SCSI supported...................... yes Supports redundant controller operation........ yes Disk write cache enabled in current page....... no Disk write cache disabled in default page...... no QAS capable (U320 only)........................ yes Currently running QAS (U320 only).............. yes ---- SCSI DEVICE 1:1 [DISK] -------------------------------------------------- Connector Location............................... internal Channel Number................................... 1 SCSI ID.......................................... 1 Device Type...................................... DISK Disk Capacity.................................... 36.4 GB Device Status.................................... OK Device Vendor ID................................. HP 36.4G Device Product ID................................ ST336754LC Device Serial Number............................. 3KQ05VWF00007535XY5J Device Firmware Version.......................... HPC2 SCSI Transfer Rate............................... Ultra-320 Reserved Area (cfg/status info).................. 557.1 KB (0.6 MB) Block Size (bytes/sector)........................ 512 bytes HP Disk Stamped?................................. yes Last Failure Reason.............................. TIMEOUT Physical Disk Flags: Disk present and operational................... yes Non-disk device detected....................... no Wide SCSI transfer enabled..................... yes Synchronous (Fast/Ultra) transfer enabled...... yes Narrow disk tray detected...................... no Wide transfer failed, reverted to narrow....... no Ultra SCSI transfer enabled.................... yes Ultra-2 SCSI transfer enabled.................. yes S.M.A.R.T. supported........................... yes S.M.A.R.T. errors (in factory M&P data)........ no S.M.A.R.T. enabled............................. yes S.M.A.R.T. errors (in powerup M&P data)........ no Attached to external channel................... no Configured in a logical drive.................. yes Configured as a spare disk..................... no Disk write cache enabled at spin up............ no Running in DT clocking mode.................... yes Supports DT clocking mode only................. no Supports DT and ST clocking modes.............. yes Running in U320 mode........................... yes Packetized SCSI supported...................... yes Supports redundant controller operation........ yes Disk write cache enabled in current page....... no Disk write cache disabled in default page...... no QAS capable (U320 only)........................ yes Currently running QAS (U320 only).............. yes ---- DIAGRAM OF EXTERNAL CONNECTORS ON BRACKET ------------------------------- ========---======== | | | U320 <--- LOOK FOR THIS LOGO | / \ | | <- | | \ / | | | | * * | | * * * * | (Ch A1)---> * * * * <--- (Ch A2) | * * * * | | * * | | | | | | | | | | | | | | | | | | | ~ ~ ~ ~ ~ ****************************************************************************** **** End of SAUTIL Output **** ******************************************************************************