State:

• System running normally. You should expect an OS prompt, if not, system may be hung.

State:

• The system crashed and rebooted itself successfully

State:

• 1. There was a system interruption that did not take the system down

State:

• System running, and
• A) unexpected reboot occurred, and
• B) a non-critical error has been detected

State:

• Executing non-OS code - no problems detected
• System may be hung or waiting for BCH response
• Potential causes could be PDC never executed (problem with fetching code from PDH), HPMC while PDC was configuring system.

State:

• Boot failed
• Executing non-OS code.

State:

• Unexpected reboot occurred
• Executing non-OS code.

State:

• Executing non-OS code.
• Non-critical error detected (ie. fan failure, power supply failure)

State:

• Boot failed
• Executing non-OS code.
• Non-critical error detected (ie. fan failure, power supply failure)

State:

• Unexpected reboot/system recovering.
• Executing non-OS code.
• Non-critical error detected (ie. fan failure, power supply failure)

State:

• A) If Power LED Off
• B) If Power LED Flashing
• C) If Power LED On

Action:

• A) Check Power Supply switches and LEDs

• Power supply switches should be on and LEDs should be on to indicate presence of AC.
• Check AC power at source

• B) Turn Front Panel Power Switch on - LED should be on solid

• If LED continues to flash, system has been remotely powered off by the service processor or the power monitor has failed.
• Execute service processor PC command: type CTRL B, log into the service processor, and type PC at the prompt.
• If this doesn't cause the LED to go on solid, problem is most likely with the power monitor.

• C) Cannot execute PDC. If more than one processor installed, the problem is most likely a failed system board. If only one processor installed, problem could be either the processor or system board.

State:

• Boot failed
• OS not up and running, PDC has detected a failure that is preventing boot from occurring.

This is an invalid indication. Check the server's LEDs and try again.

State:

• No code is executing (PDC, OS or Diagnostics)
• Non-critical error detected (ie. fan failure, power supply failure) (Double fault situation)

State:

• Boot failed
• OS not up and running, PDC has detected a failure that is preventing boot from occurring.
• Non-critical error detected (ie. fan failure, power supply failure)

This is an invalid indication. Check the server's LEDs and try again.