
Event header details:
Event sequence number: 423948
Flags: Time_set Time_synched Primary_Ctlr 
Event rev: 2
Event size: 180
Software version: 6250
Base level: CR1FCA      
Ctlr model: HSV210  
Ctlr handle: 0000-7-8-500508B4-000701F1-00000000-00000000
Report time: 27 Oct, 2012 13:56:50.489717
Location: 0x0012A1BC
Event code: Type: 17 Cac: 00 Num: 41 Scid: 06
Event description: 0x06410017 Severity: Normal -- informational in nature. The device loop configuration has changed on a HSV210 controller's Fibre Channel port. This informational event contains a page of the newly genereated fibre channel loop map. Devices are listed in loop order using their ALPAs.
Information packet rev: 01
Information packet type: 17
Information packet size: 0074
Software component: Fibre Channel Services
Corrective action: No action necessary.

Event structure details:
Information packet descriptor:
EIP17 - Fibre Channel Services Fibre Channel Port Loop Config
A new device map has been generated on a Fibre Channel port.
Structure: Event
  Structure: flags
    time_set: TRUE - Time has been set on this HSV210 controller
    time_synched: TRUE - Time has been synchronized with all HSV210 controllers in the Storage System
    seq_reset: FALSE - Event sequence number reset occurred
    outofsequence: FALSE - Event reported out of sequence due to Final Event Block reconciliation or lost host event
    requeued: FALSE - Event requeued following restart or resynchronization
    labcode: FALSE - Event reported using LAB code
    prictrlr: TRUE - Event reported by primary HSV210 controller (Note: Not valid until Storage System primary HSV210 controller is elected)
    spsctrlr: FALSE - Single power supply HSV210 controller
  End of structure
  revision: 2 [0x02] - Structure revision number
  count: 180 [0x00B4] - Event specific information size in bytes
  sequence_number: 423948 [0x0006780C] - Sequence number assigned to the event
  sw_version: 6250 - HSV210 controller software version number string
  baselevel_id: CR1FCA       - HSV210 controller baselevel build string
  ctrlr_model_id: HSV210   - HSV210 controller model string
  reporting_ctrlr: 0000-7-8-500508B4-000701F1-00000000-00000000 - Storage System Management Interface Handle of HSV210 controller that reported the event
  report_time: 27 Oct, 2012 13:56:50.489717 - Time event was reported
  report_location: 1221052 [0x0012A1BC] - Location of event report call
  Structure: header
    Union: u
      Structure: ec
        eiptype: 23 [0x17] - Event Information Packet Type Code
        cac: 0 [0x00] - Corrective Action Code
        evnum: 65 [0x41] - Event Number
        scid: 6 [0x06] - HSV210 Controller Software Component Identification
      End of structure
    End of union section
      value: 104923159 [0x06410017] - Event Code Value
    End of union
    End of union
    revision: 1 [0x01] - Packet revision number
    type: 23 [0x17] - Packet type
    count: 116 [0x0074] - Number of bytes in packet
  End of structure
  cerp_id: DP-2A    - HSV210 controller enclosure rear panel Fibre Channel port
  map_id: 555344547 [0x2119E2A3] - Multi-page map identifier (all pages containing this identifier comprise this map)
  entries: 92 [0x5C] - Number of map entries (AL_PAs) in this map
  total_pages: 2 [0x02] - Total pages containing portions of this map
  page: 1 [0x01] - Page number of this loop map event
  port: 2 [0x02] - HSV210 controller internal Fibre Channel port number
  loop_map: 1 [0x01]106 [0x6A]105 [0x69]103 [0x67]102 [0x66]101 [0x65]99 [0x63]92 [0x5C]90 [0x5A]89 [0x59]86 [0x56]85 [0x55]84 [0x54]83 [0x53]82 [0x52]182 [0xB6]181 [0xB5]180 [0xB4]179 [0xB3]178 [0xB2]177 [0xB1]174 [0xAE]173 [0xAD]172 [0xAC]171 [0xAB]170 [0xAA]169 [0xA9]167 [0xA7]166 [0xA6]209 [0xD1]206 [0xCE]205 [0xCD]204 [0xCC]203 [0xCB]202 [0xCA]201 [0xC9]199 [0xC7]198 [0xC6]197 [0xC5]195 [0xC3]239 [0xEF]232 [0xE8]228 [0xE4]226 [0xE2]225 [0xE1]224 [0xE0]220 [0xDC]218 [0xDA]217 [0xD9]214 [0xD6]213 [0xD5]54 [0x36]53 [0x35]52 [0x34]51 [0x33]50 [0x32]49 [0x31]46 [0x2E]45 [0x2D]44 [0x2C]43 [0x2B]42 [0x2A]41 [0x29]39 [0x27]38 [0x26]128 [0x80]124 [0x7C]122 [0x7A]121 [0x79]118 [0x76]117 [0x75]116 [0x74]115 [0x73]114 [0x72]113 [0x71]110 [0x6E]109 [0x6D]108 [0x6C]107 [0x6B]37 [0x25]35 [0x23]31 [0x1F]30 [0x1E]29 [0x1D]27 [0x1B]24 [0x18]23 [0x17]16 [0x10]15 [0x0F]8 [0x08]81 [0x51]78 [0x4E] - Loop configuration information
End of structure

Salient data:
Event: Severity: Normal -- informational in nature. The device loop configuration has changed on a HSV210 controller's Fibre Channel port. This informational event contains a page of the newly genereated fibre channel loop map. Devices are listed in loop order using their ALPAs.
Action: No action necessary.