
Event header details:
Event sequence number: 423949
Flags: Time_set Time_synched Primary_Ctlr 
Event rev: 2
Event size: 180
Software version: 6250
Base level: CR1FCA      
Ctlr model: HSV210  
Ctlr handle: 0000-7-8-500508B4-000701F1-00000000-00000000
Report time: 27 Oct, 2012 13:56:50.489724
Location: 0x0012A1BC
Event code: Type: 17 Cac: 00 Num: 41 Scid: 06
Event description: 0x06410017 Severity: Normal -- informational in nature. The device loop configuration has changed on a HSV210 controller's Fibre Channel port. This informational event contains a page of the newly genereated fibre channel loop map. Devices are listed in loop order using their ALPAs.
Information packet rev: 01
Information packet type: 17
Information packet size: 0074
Software component: Fibre Channel Services
Corrective action: No action necessary.

Event structure details:
Information packet descriptor:
EIP17 - Fibre Channel Services Fibre Channel Port Loop Config
A new device map has been generated on a Fibre Channel port.
Structure: Event
  Structure: flags
    time_set: TRUE - Time has been set on this HSV210 controller
    time_synched: TRUE - Time has been synchronized with all HSV210 controllers in the Storage System
    seq_reset: FALSE - Event sequence number reset occurred
    outofsequence: FALSE - Event reported out of sequence due to Final Event Block reconciliation or lost host event
    requeued: FALSE - Event requeued following restart or resynchronization
    labcode: FALSE - Event reported using LAB code
    prictrlr: TRUE - Event reported by primary HSV210 controller (Note: Not valid until Storage System primary HSV210 controller is elected)
    spsctrlr: FALSE - Single power supply HSV210 controller
  End of structure
  revision: 2 [0x02] - Structure revision number
  count: 180 [0x00B4] - Event specific information size in bytes
  sequence_number: 423949 [0x0006780D] - Sequence number assigned to the event
  sw_version: 6250 - HSV210 controller software version number string
  baselevel_id: CR1FCA       - HSV210 controller baselevel build string
  ctrlr_model_id: HSV210   - HSV210 controller model string
  reporting_ctrlr: 0000-7-8-500508B4-000701F1-00000000-00000000 - Storage System Management Interface Handle of HSV210 controller that reported the event
  report_time: 27 Oct, 2012 13:56:50.489724 - Time event was reported
  report_location: 1221052 [0x0012A1BC] - Location of event report call
  Structure: header
    Union: u
      Structure: ec
        eiptype: 23 [0x17] - Event Information Packet Type Code
        cac: 0 [0x00] - Corrective Action Code
        evnum: 65 [0x41] - Event Number
        scid: 6 [0x06] - HSV210 Controller Software Component Identification
      End of structure
    End of union section
      value: 104923159 [0x06410017] - Event Code Value
    End of union
    End of union
    revision: 1 [0x01] - Packet revision number
    type: 23 [0x17] - Packet type
    count: 116 [0x0074] - Number of bytes in packet
  End of structure
  cerp_id: DP-2A    - HSV210 controller enclosure rear panel Fibre Channel port
  map_id: 555344547 [0x2119E2A3] - Multi-page map identifier (all pages containing this identifier comprise this map)
  entries: 28 [0x1C] - Number of map entries (AL_PAs) in this map
  total_pages: 2 [0x02] - Total pages containing portions of this map
  page: 2 [0x02] - Page number of this loop map event
  port: 2 [0x02] - HSV210 controller internal Fibre Channel port number
  loop_map: 77 [0x4D]76 [0x4C]75 [0x4B]74 [0x4A]73 [0x49]71 [0x47]70 [0x46]69 [0x45]67 [0x43]60 [0x3C]58 [0x3A]57 [0x39]165 [0xA5]163 [0xA3]159 [0x9F]158 [0x9E]157 [0x9D]155 [0x9B]152 [0x98]151 [0x97]144 [0x90]143 [0x8F]136 [0x88]132 [0x84]130 [0x82]129 [0x81]2 [0x02]4 [0x04]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF]255 [0xFF] - Loop configuration information
End of structure

Salient data:
Event: Severity: Normal -- informational in nature. The device loop configuration has changed on a HSV210 controller's Fibre Channel port. This informational event contains a page of the newly genereated fibre channel loop map. Devices are listed in loop order using their ALPAs.
Action: No action necessary.