HP Array Configuration Utility CLI 9.40.12.0
Detecting Controllers...Done.
Type "help" for a list of supported commands.
Type "exit" to close the console.

=> ctrl slot=1 show config

Smart Array P400 in Slot 1                (sn: PA2240J9SU33K2)

   array A (SAS, Unused Space: 0  MB)


      logicaldrive 1 (68.3 GB, RAID 1, Interim Recovery Mode)

      physicaldrive 1I:1:2 (port 1I:box 1:bay 2, SAS, 0 MB, Failed)
      physicaldrive 2I:1:1 (port 2I:box 1:bay 1, SAS, 72 GB, OK)

   unassigned

      physicaldrive 2I:1:3 (port 2I:box 1:bay 3, SAS, 72 GB, OK)

=> ctrl slot=1 show config detail

Smart Array P400 in Slot 1
   Bus Interface: PCI
   Slot: 1
   Serial Number: PA2240J9SU33K2
   Cache Serial Number: PA82C0H9VVD0FH
   RAID 6 (ADG) Status: Disabled
   Controller Status: OK
   Hardware Revision: B
   Firmware Version: 7.24
   Rebuild Priority: Medium
   Expand Priority: Medium
   Surface Scan Delay: 15 secs
   Surface Scan Mode: Idle
   Wait for Cache Room: Disabled
   Surface Analysis Inconsistency Notification: Disabled
   Post Prompt Timeout: 0 secs
   Cache Board Present: True
   Cache Status: OK
   Cache Status Details: A cache error was detected. Run a diagnostic report for
 more information.
   Cache Ratio: 100% Read / 0% Write
   Drive Write Cache: Disabled
   Total Cache Size: 256 MB
   Total Cache Memory Available: 208 MB
   No-Battery Write Cache: Disabled
   Battery/Capacitor Count: 0
   SATA NCQ Supported: False

   Array: A
      Interface Type: SAS
      Unused Space: 0  MB
      Status: Failed Physical Drive
      Array Type: Data

      One of the drives on this array have failed or has been removed.




      Logical Drive: 1
         Size: 68.3 GB
         Fault Tolerance: 1
         Heads: 255
         Sectors Per Track: 32
         Cylinders: 17562
         Strip Size: 128 KB
         Full Stripe Size: 128 KB
         Status: Interim Recovery Mode
         Caching:  Enabled
         Unique Identifier: 600508B1001037393520202020200007
         Disk Name: \\.\PhysicalDrive0 (Disk 0) (Bus: 0,Target: 4,Lun: 0)
         Mount Points: C:\ 68.3 GB
         Logical Drive Label: A008AFB0P683MR4795     3577
         Mirror Group 0:
            physicaldrive 1I:1:2 (port 1I:box 1:bay 2, SAS, 0 MB, Failed)
         Mirror Group 1:
            physicaldrive 2I:1:1 (port 2I:box 1:bay 1, SAS, 72 GB, OK)
         Drive Type: Data

      physicaldrive 1I:1:2
         Port: 1I
         Box: 1
         Bay: 2
         Status: Failed
         Last Failure Reason: Hot plug start unit failed
         Drive Type: Data Drive
         Interface Type: SAS
         Size: 0 MB

      physicaldrive 2I:1:1
         Port: 2I
         Box: 1
         Bay: 1
         Status: OK
         Drive Type: Data Drive
         Interface Type: SAS
         Size: 72 GB
         Rotational Speed: 10000
         Firmware Revision: HPDB
         Serial Number:         P2VUNE5A
         Model: HP      DG072BAAJA
         Current Temperature (C): 29
         Maximum Temperature (C): 43
         PHY Count: 2
         PHY Transfer Rate: Unknown, Unknown


   unassigned

      physicaldrive 2I:1:3
         Port: 2I
         Box: 1
         Bay: 3
         Status: OK
         Drive Type: Unassigned Drive
         Interface Type: SAS
         Size: 72 GB
         Rotational Speed: 10000
         Firmware Revision: HPDA
         Serial Number:         P2XNYZUA
         Model: HP      DG072BAAJA
         Current Temperature (C): 27
         Maximum Temperature (C): 42
         PHY Count: 2
         PHY Transfer Rate: Unknown, Unknown