ProCurve Switch 2610-24-PWR(config)# span
 bpdu-protection-ti... Set the time for protected ports to be in down state
                       after receiving unauthorized BPDUs.
 clear-debug-counters  Clear spanning tree debug counters.
 config-name           Set the MST region configuration name (default is
                       switch's MAC address).
 config-revision       Set the MST region configuration revision number
                       (default is 0).
 force-version         Set Spanning Tree protocol compatibility mode.
 forward-delay         Set time the switch waits between transitioning from
                       listening to learning and from learning to forwarding
                       states.
 hello-time            Set time between messages transmission when the switch
                       is root.
 instance              Create, delete or configure an MST instance.
 legacy-mode           Set spanning-tree protocol to operate either in 802.1d
                       legacy mode or in 802.1s native mode.
 legacy-path-cost      Set 802.1d (legacy) or 802.1t (not legacy) default
                       pathcost values.
 max-hops              Set the max number of hops in a region before the MST
                       BPDU is discarded and the information held for a port is
                       aged (default is 20).
 maximum-age           Set maximum age of received STP information before it is
                       discarded.
 pending               Manipulate pending MSTP configuration.
 [ethernet] PORT-LIST  Configure the port-specific parameters of the spanning
                       tree protocol for individual ports.
 priority              Set the device STP priority (the value is in range of
                       0-61440 divided into steps of 4096 that are numbered
                       from 0 to 15, default is step 8).
 trap                  Enable/disable STP traps.