root@jxpapidb:/#sautil /dev/ciss0

******************************************************************************
****                                                                      ****
****             S A U T I L   S u p p o r t   U t i l i t y              ****
****                                                                      ****
****             for the HP SmartArray RAID Controller Family             ****
****                                                                      ****
****                           version A.02.16                            ****
****                                                                      ****
****  (C) Copyright 2003-2010 Hewlett-Packard Development Company, L.P.   ****
******************************************************************************



---- DRIVER INFORMATION ------------------------------------------------------

  Driver State........................ READY

---- CONTROLLER INFORMATION --------------------------------------------------

  Controller Product Number........... P410i
  Controller Product Name............. HP PCIe SmartArray P410i
  Controller mode..................... HBA MODE
  Hardware Path....................... 0/0/0/2/0/0/0
  Serial Number....................... 5001438013F9935A
  Device File......................... /dev/ciss0
  Hardware Revision................... 'C'
  Boot Block Revision................. 2.16
  Firmware Revision (running)......... 3.66
  Firmware Revision (in ROM).......... 3.66
  Firmware Revision (inactive)........ 3.66
  # of Logical Drives................. 0
  # of Physical Disks Configured...... 0
  # of Physical Disks Detected........ 2
  Logical Drive Rebuild Priority...... 0   (low)
  Array Capacity Expansion Priority... 0   (low)
  Auto-Fail Missing Disks at Boot..... disabled
  SCSI Transfer Detection Mode........ Auto Detect
  Controller Path Selection Method.... default
  Max # of Logical Drives............. 2
  Last firmware lockup................ 0


---- ARRAY ACCELERATOR (CACHE) INFORMATION -----------------------------------

  Array Accelerator Board Present?.... no
  Cache Configuration Status.......... cache NOT configured
  Cache Ratio......................... N/A
  Total Cache Size (MB)............... 000
    Read Cache........................ N/A
    Write Cache....................... N/A
    Transfer Buffer................... N/A
  Battery Pack Count.................. 0


---- LOGICAL DRIVE SUMMARY ---------------------------------------------------

       #   RAID      Size        Status

     [ No logical drive(s) detected ]


---- SAS/SATA DEVICE SUMMARY -------------------------------------------------

  Location  Ct Enc Bay       WWID           Type        Capacity Status

  internal  1I   1   1  0x500003932822a85e  DISK       600.1 GB  RAW DISK
  internal  1I   1   2  0x500003932822b50e  DISK       600.1 GB  RAW DISK


---- SAS/SATA ENCLOSURE SUMMARY ----------------------------------------------

  Location  Ct   Enc  Expander_count    Bay_count     SEP_count

  internal  1I   1    0                 2             1


---- SAS/SATA DEVICE 1I:1:1:0x500003932822a85e [DISK] ------------------------

  Device File...................................... /dev/dsk/c0t8d0
  Connector Location............................... internal
  Connector........................................ 1I
  Enclosure........................................ 1
  Bay.............................................. 1
  WWID............................................. 0x500003932822a85e
  Device Type...................................... DISK
  Disk Capacity.................................... 600.1 GB
  Device Status.................................... RAW DISK
  Device Vendor ID................................. HP
  Device Product ID................................ EG0600FBDSR
  Device Serial Number............................. EA01PB30J4BY1111
  Device Firmware Version.......................... HPD2
  Reserved Area (cfg/status info).................. 33554.4 KB (33.6 MB)
  Block Size (bytes/sector)........................ 512 bytes
  M&P Data Stamped?................................ yes
  Last Failure Reason.............................. none

  Physical Disk Flags:
    Disk present and operational................... yes
    Non-disk device detected....................... no

    S.M.A.R.T. supported........................... yes
    S.M.A.R.T. errors (in factory M&P data)........ no
    S.M.A.R.T. enabled............................. yes
    S.M.A.R.T. errors (in powerup M&P data)........ no
    Attached to external connector................. no
    Configured in a logical drive.................. no
    Configured as a spare disk..................... no
    Disk write cache enabled at spin up............ no

    Supports redundant controller operation........ yes
    Disk write cache enabled in current page....... no
    Disk write cache disabled in default page...... yes




---- SAS/SATA DEVICE 1I:1:2:0x500003932822b50e [DISK] ------------------------

  Device File...................................... /dev/dsk/c0t8d1
  Connector Location............................... internal
  Connector........................................ 1I
  Enclosure........................................ 1
  Bay.............................................. 2
  WWID............................................. 0x500003932822b50e
  Device Type...................................... DISK
  Disk Capacity.................................... 600.1 GB
  Device Status.................................... RAW DISK
  Device Vendor ID................................. HP
  Device Product ID................................ EG0600FBDSR
  Device Serial Number............................. EA01PB30J4NA1111
  Device Firmware Version.......................... HPD2
  Reserved Area (cfg/status info).................. 33554.4 KB (33.6 MB)
  Block Size (bytes/sector)........................ 512 bytes
  M&P Data Stamped?................................ yes
  Last Failure Reason.............................. none

  Physical Disk Flags:
    Disk present and operational................... yes
    Non-disk device detected....................... no

    S.M.A.R.T. supported........................... yes
    S.M.A.R.T. errors (in factory M&P data)........ no
    S.M.A.R.T. enabled............................. yes
    S.M.A.R.T. errors (in powerup M&P data)........ no
    Attached to external connector................. no
    Configured in a logical drive.................. no
    Configured as a spare disk..................... no
    Disk write cache enabled at spin up............ no

    Supports redundant controller operation........ yes
    Disk write cache enabled in current page....... no
    Disk write cache disabled in default page...... yes





******************************************************************************
****                         End of SAUTIL Output                         ****
******************************************************************************