ps result: HW status for Cell 0 : FAILURE DETECTED Power status : on, no fault Faults above are latched. They are cleared just before the cell is powered on. Boot is blocked PDH memory is not shared Processor Compatibility : FAULT RIO cable status : connected RIO cable connection physical location : PCI Domain 0 Core cell is INVALID Attention Led is off PDHC status Leds : --*- CPU Module Slot 0 1 2 3 Populated Local 48V Good Power Enabled Power Good (* - True, P - Processor, T - Terminator) | DIMM Presence | | | | Side: | A | B | |Echelon: |01234567|01234567| +---------+--------+--------+ | |******** ********| 1 1 1 1 1 1 VRM's 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 Present : * * * * * * * * * * * * * * * * Enabled : * * * * * * * * * * * * * * * * Pwr Good : * * * * * * * * * * * * * * * * Front Side Bus Freq. : 267 MHz CPU Core Freq. : 0 MHz CPU Part Number : System Boot Rom (SFW) firmware rev 009.048.000 PDH controller (PDHC) firmware rev B.023.003.040 built SUN AUG 05 21:53:18 2007 firmware upgrade: 1, Please enter selection(s): 0 You have selected: IPF_FW Cabinet 0, Cell 0 Begin update? (Y/[N]) y Checking update state of IPF_FW in Cabinet 0 Cell 0 ....... Warning: Update is not recommended, hardware version(s) conflict! Entity hardware version: 0xa02100 File hardware versions: 0x424246 0x424247 0x424248 ** UPDATING FIRMWARE MAY RENDER BOARD UNUSABLE ** 2, Please enter selection(s): 0 You have selected: PDHC Cabinet 0, Cell 0 Begin update? (Y/[N]) y Checking update state of PDHC in Cabinet 0 Cell 0 ....... Warning: Update is not recommended, hardware version(s) conflict! Entity hardware version: 0x21a0 File hardware versions: 0x4242 ** UPDATING FIRMWARE MAY RENDER BOARD UNUSABLE ** 3, Checking update state of CELL_JTAG in Cabinet 0 Cell 0 ....... Updating CELL_JTAG to version 001.002.000 Percent Complete 0..........25..........50..........75..........100 Physical Location New Firmware Revision Update Status -------------------------------------- ------------------------ ------------- CELL_JTAG Cabinet 0, Cell 0 001.002.000 PASSED 4, Checking update state of CELL_LPM in Cabinet 0 Cell 0 ....... Updating CELL_LPM to version 001.002.000 Percent Complete 0..........25..........50..........75..........100 Physical Location New Firmware Revision Update Status -------------------------------------- ------------------------ ------------- CELL_LPM Cabinet 0, Cell 0 001.002.000 PASSED