https://community.hpe.com/t5/array-setup-and-networking/multipathing-setup-for-iscsi-connection-to-xenserver/m-p/7043805#M2358 <P>Similar to ESXi port binding, does this help?&nbsp; <A href="https://support.citrix.com/article/CTX138429" target="_blank">https://support.citrix.com/article/CTX138429</A></P> Thu, 25 Apr 2019 15:43:14 GMT mamatadesaiNim 2019-04-25T15:43:14Z https://community.hpe.com/t5/array-setup-and-networking/multipathing-setup-for-iscsi-connection-to-xenserver/m-p/7043754#M2357 <P>I have a Nimble array that has been configured with 2 iSCSI Data IP Addresses and 1 discovery address.&nbsp; My XenServers have 2 NICs configured for iSCSI connectivity and are on the same subnet as the 2 data and 1 discovery addresses on the Nimble.&nbsp; I have connectivity from teh XenServer to the array and can connect fine, however it is only using one connection.&nbsp; I have used the discovery address to connect the XenServer to the Nimble but I need to get connectivity via both NICs for multipathing to work.&nbsp; I am used to working with VMware ESXi and so am looking for how to use both NICs on XenServer to be used for the iSCSI connection</P><P>&nbsp;</P><P>Thanks</P><P>&nbsp;</P><P>Chris</P> Thu, 25 Apr 2019 08:04:58 GMT https://community.hpe.com/t5/array-setup-and-networking/multipathing-setup-for-iscsi-connection-to-xenserver/m-p/7043754#M2357 chrisp10 2019-04-25T08:04:58Z https://community.hpe.com/t5/array-setup-and-networking/multipathing-setup-for-iscsi-connection-to-xenserver/m-p/7043805#M2358 <P>Similar to ESXi port binding, does this help?&nbsp; <A href="https://support.citrix.com/article/CTX138429" target="_blank">https://support.citrix.com/article/CTX138429</A></P> Thu, 25 Apr 2019 15:43:14 GMT https://community.hpe.com/t5/array-setup-and-networking/multipathing-setup-for-iscsi-connection-to-xenserver/m-p/7043805#M2358 mamatadesaiNim 2019-04-25T15:43:14Z