https://community.hpe.com/t5/array-setup-and-networking/command-to-check-open-ports/m-p/7134303#M2728 <P>Trying to validate whether the right ports are open from Nimble to vCenter. I found <A title="Nimble OS command to check open ports?" href="https://community.hpe.com/t5/Array-Setup-and-Networking/Nimble-OS-command-to-check-open-ports/td-p/6984279" target="_blank" rel="noopener">this thread from 2016</A> asking the same question, the answer to which says that 'telnet' works. However, when I log in to the CLI on my Nimble (OS version 5.0.10) and try that it does this:</P><LI-CODE lang="markup">Nimble OS $ telnet bash: telnet: command not found</LI-CODE><P>Did 'telnet' get removed and replaced by a different command in later versions of the OS? Or is there maybe an advanced CLI mode I have to switch into in order for that command to be available?</P> Fri, 14 May 2021 16:42:34 GMT hux 2021-05-14T16:42:34Z https://community.hpe.com/t5/array-setup-and-networking/command-to-check-open-ports/m-p/7134303#M2728 <P>Trying to validate whether the right ports are open from Nimble to vCenter. I found <A title="Nimble OS command to check open ports?" href="https://community.hpe.com/t5/Array-Setup-and-Networking/Nimble-OS-command-to-check-open-ports/td-p/6984279" target="_blank" rel="noopener">this thread from 2016</A> asking the same question, the answer to which says that 'telnet' works. However, when I log in to the CLI on my Nimble (OS version 5.0.10) and try that it does this:</P><LI-CODE lang="markup">Nimble OS $ telnet bash: telnet: command not found</LI-CODE><P>Did 'telnet' get removed and replaced by a different command in later versions of the OS? Or is there maybe an advanced CLI mode I have to switch into in order for that command to be available?</P> Fri, 14 May 2021 16:42:34 GMT https://community.hpe.com/t5/array-setup-and-networking/command-to-check-open-ports/m-p/7134303#M2728 hux 2021-05-14T16:42:34Z