https://community.hpe.com/t5/array-setup-and-networking/10gbaset-interfaces-eth0a-amp-eth0b/m-p/7143257#M2752 <P>We're preparing to install/configure our first Nimble arrays, an AF40 and HF40.&nbsp; We've patched the OM3 connections for 16Gbps FC (block), but I wanted to know if there's any issue with the&nbsp;10GBaseT Interfaces eth0a &amp; eth0b running at 1GbE if we're only using them for redundant management ports.</P><P>Since we're not using those interfaces for iSCSI, will they only be used for replication or if we wanted to support SMB or NFS directly from the arrays?&nbsp; Thank you.</P> Wed, 21 Jul 2021 21:32:32 GMT sgunelius 2021-07-21T21:32:32Z https://community.hpe.com/t5/array-setup-and-networking/10gbaset-interfaces-eth0a-amp-eth0b/m-p/7143257#M2752 <P>We're preparing to install/configure our first Nimble arrays, an AF40 and HF40.&nbsp; We've patched the OM3 connections for 16Gbps FC (block), but I wanted to know if there's any issue with the&nbsp;10GBaseT Interfaces eth0a &amp; eth0b running at 1GbE if we're only using them for redundant management ports.</P><P>Since we're not using those interfaces for iSCSI, will they only be used for replication or if we wanted to support SMB or NFS directly from the arrays?&nbsp; Thank you.</P> Wed, 21 Jul 2021 21:32:32 GMT https://community.hpe.com/t5/array-setup-and-networking/10gbaset-interfaces-eth0a-amp-eth0b/m-p/7143257#M2752 sgunelius 2021-07-21T21:32:32Z https://community.hpe.com/t5/array-setup-and-networking/10gbaset-interfaces-eth0a-amp-eth0b/m-p/7143318#M2753 <P>Hi,</P><P>Nimble offer today no NFS or CIFS Service.</P><P>The Ports are used for Management and Replication.</P><P>If you do not use Replication, it's fine.</P><P>If you use Replication, Async is fine, but for Syncrounos 1GB is too slow.</P><P>Cali</P> Thu, 22 Jul 2021 11:41:13 GMT https://community.hpe.com/t5/array-setup-and-networking/10gbaset-interfaces-eth0a-amp-eth0b/m-p/7143318#M2753 Cali 2021-07-22T11:41:13Z