topic Query: Adding multiple NTP/DNS Sources in Array Setup and Networking

Adding multiple NTP/DNS Sources

adamdb_uk — Tue, 10 Dec 2024 09:25:15 GMT

Hi,

can anyone advise the syntax to add multiple NTP and DNS sources to an Alletra 6000 (Nimble) storage system

group --edit --ntpserver xx.xx.xx.xx is the command but I cannot work out the syntax to add multiple NTP targets.

Similarly for DNS

group --edit --dnsserver xx.xx.xx.xx --domainname name

I've tried adding them as a list, using semi-colons, commas, etc.

placing the two entries in double/single quotes with and without the above.

I know on 3PAR you can do it with double quotes and semi-colons so i was hoping for something similar.

Can't see any examples anywhere hence the question.

Thanks.

Re: Adding multiple NTP/DNS Sources

Mahesh202 — Wed, 11 Dec 2024 04:20:00 GMT

Hi adamdb_uk

you may try with the below command

group --edit --ntpserver ip address
group --edit --ntpserver <server IP>

to verify once you have modified the server:
group --info | grep -i ntp

After deployment, you cannot add/edit multiple NTP servers in the GUI or CLI.

and for DNS please run this command group --edit --dnsserver ipaddress 1, ipaddress 2

You can add it from the GUI
1. Click on Administration >>Network>>DNS
2. Add multiple DNS servers
3. Save

hope this helps.!!

Regards
Mahesh

Query: Adding multiple NTP/DNS Sources

support_s — Mon, 16 Dec 2024 13:48:56 GMT

Hello,

Let us know if you were able to resolve the issue.

If you have no further query, and you are satisfied with the answer then kindly mark the topic as Solved so that it is helpful for all community members.

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

Thank you for being a HPE valuable community member.