topic Re: Qlogic HBA ARP Redirect in Array Setup and Networking

Qlogic HBA ARP Redirect

mr_vaughn — Tue, 15 Apr 2014 01:38:12 GMT

I have a client migrating to a a Nimble SAN and once finished we are going to have 2 paths per ESXi server. This will be using the Qlogic QLE4062 iSCSI HBA.

Question is in the configuration of each HBA you can enable Arp Redirection. Do we do this with Nimble?

I have seen this be required for SAN's similar to Nimble's.

Re: Qlgoic HBA & arp redirect

gcostanza71 — Wed, 16 Apr 2014 00:58:59 GMT

The Nimble best practice is to use a software iSCSI adapter however a hardware HBA will work. Also be cognizant that some hardware adapters provide less iSCSI connections than software adapters and I am aware of a customer that reverted to the software adapter to get to the higher number of connecitons.

According to Nimble support Nimble does not need ARP redirect so you can leave it off. One of my peers recently installed a Nimble array in a configuration that had a Qlogic 4062 ISCSI HBA with hardware initiator for ISCSI traffic. He pointed out that unlike a software adapter dynamic discovery won’t work and you have to use static discovery to pick up the Nimble volumes. Also a vSwitch was not required in this configuration since it was direct from initiator (w/ vmhba) to array target ports.

Hope this helps.

Re: Qlgoic HBA & arp redirect

gcostanza71 — Wed, 16 Apr 2014 15:48:15 GMT

More for Nimble support

"To verify that the correct drivers are in use, flowcontrol will be on by default for ESXi. This can be checked from the ESXi server CLI using the following command.

ethtool --show-pause -vnicX

VMware's page is here and explains how to set flow control for the NIC.

If you can not set flow control for the NIC, or it is not automatically on, it is a very good indication that the driver is incorrect for the adapter/VNIC"

http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1013413

Re: Qlogic HBA ARP Redirect

mr_vaughn — Thu, 01 May 2014 16:28:09 GMT

Note that the Qlogic represents itself only as an Storage HBA to ESXi and not as a network adapter.

Re: Qlogic HBA ARP Redirect

mr_vaughn — Thu, 01 May 2014 16:30:26 GMT

I remember trying to use fancy Qlogic 10Gb cards with an iSCSI offload function and had the discovery issue too. With that 10Gb we went soft iSCSI. Since it was dedicated 10Gb nic for just the SAN.