topic Re: FW synchronization algorithm when replacing P2000 MSA G3 controller in HPE MSA Storage

FW synchronization algorithm when replacing P2000 MSA G3 controller

sfuji — Thu, 20 Feb 2020 04:31:23 GMT

G4/G5世代のMSAのSMUリファレンスガイドには保守部品のコントローラー交換を実施した場合、元のコントローラーから交換部品へFWが同期されるとの記載があるが、P2000 MSA G3には同様の記載が見つかりませんでした。

G3のMSAも同様のFW同期アルゴリズムが動作するのか確認したい。

Google Translated

The SMU reference guide for the G4 / G5 generation MSA states that if a maintenance part controller is replaced, the FW will be synchronized from the original controller to the replacement part. Could not be located. I want to check if the same FW synchronization algorithm works for G3 MSA.

Re: FW synchronization algorithm when replacing P2000 MSA G3 controller

Cali — Thu, 20 Feb 2020 15:15:24 GMT

Hi,

go to the CLI and enter:

show advanced-settings

Look for

Partner Firmware Upgrade

The command is:

set advanced-settings partner-firmware-upgrade enabled|disabled|on|off

Cali

Re: FW synchronization algorithm when replacing P2000 MSA G3 controller

Torsten. — Thu, 20 Feb 2020 15:27:26 GMT

For the P2000 (MSA2000 G3) the controller with the newer firmware clones to the controller with the older firmware.

This is different to G4 and G5 (see above).