https://community.hpe.com/t5/hpe-msa-storage/eva5000-loop-pair-failure/m-p/699345#M2561 I received a notification from Command Veiw stating that a loop pair failure occurred. If I look at the EVA5000 itself there are no flasking red lights, no errors on the display, nothing to indicate a failure. Yet if I look in Command View and I look at the "Device Ports" tab under either controller it shows the ooperationals state as "Failed". If I try to enable it, it does nothing. Any ideas how to correct this? Mon, 18 Sep 2006 07:02:57 GMT CA1012336 2006-09-18T07:02:57Z https://community.hpe.com/t5/hpe-msa-storage/eva5000-loop-pair-failure/m-p/699345#M2561 I received a notification from Command Veiw stating that a loop pair failure occurred. If I look at the EVA5000 itself there are no flasking red lights, no errors on the display, nothing to indicate a failure. Yet if I look in Command View and I look at the "Device Ports" tab under either controller it shows the ooperationals state as "Failed". If I try to enable it, it does nothing. Any ideas how to correct this? Mon, 18 Sep 2006 07:02:57 GMT https://community.hpe.com/t5/hpe-msa-storage/eva5000-loop-pair-failure/m-p/699345#M2561 CA1012336 2006-09-18T07:02:57Z