topic Re: trying to acces NSR 1200 on MSL 6000 in Automated Backup

trying to acces NSR 1200 on MSL 6000

daedro — Mon, 08 Aug 2011 08:45:54 GMT

Hi, im tying to acces a NSR 1200 on MSL 6000 but i dont know the ip, i reset de card and i know that by default there is a DHCP active, some body know how can i find out the ip address of the card to access, i tryed too, to acces by serial cable but without exit.

thank you in advance

Re: trying to acces NSR 1200 on MSL 6000

Johan Guldmyr — Mon, 08 Aug 2011 09:04:23 GMT

Hi!

http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/lpg29075/lpg29075.pdf

Did you check out the manual for the NSR 1200?

See page 93 for the settings required (115200, 8, 1, none, xon/xoff).

If it's done by DHCP maybe you can find the IP it gets through the DHCP server or through the DNS?

It also says in the same document that "The default IP address of the router is 1.1.1.1"

Re: trying to acces NSR 1200 on MSL 6000

Marino Meloni_1 — Mon, 08 Aug 2011 10:10:13 GMT

you should be able to access from the serial port as it is the way to set the ip address.

out of that, you can check on your dhcp server log, for the ip assigned to the router,

or you can try a ping "router" and see what it the ip address returned after the resolution

the default name is "router" so if nobody chaned it, you may get access using that method

Re: trying to acces NSR 1200 on MSL 6000

daedro — Mon, 08 Aug 2011 10:30:55 GMT

hi Johan thank you for the response, I did all this things exactly like you tell me in your post, but doesnt work, there is a way to reset the card to let it to factory defaults? there is some app so i can to obtain the ip directly connecting my laptop to the NSR by cross cable, thanks

Re: trying to acces NSR 1200 on MSL 6000

Johnc_3 — Fri, 12 Aug 2011 17:00:48 GMT

Hi,

I've had a lot of trouble connecting to these NSR's in the past.

The first thing to check is that the cable is the correct one. A quick check is to look at the number of connections on teh RJ-11. If it's only 4 then you have the wrong cable; it should be 6. I've attached a diagram of the pinouts for this.

There is a factory reset button - I've never seen it documented anywhere but I know it's the hole next to the power LED; use a paperclip to hold it in for ten seconds.

Hope this helps,

John

Re: trying to acces NSR 1200 on MSL 6000

daedro — Wed, 14 Sep 2011 13:49:28 GMT

Thanks John,

could you please give me the part number of the serial cable to acces to NSR.

thank you

Re: trying to acces NSR 1200 on MSL 6000

Johnc_3 — Thu, 15 Sep 2011 09:54:46 GMT

I've found a couple of P/Ns for this cable: 300576-001 & 259772-001.

I had a cable made up for me using the cable pinouts detailed in the diagram I previously posted.

Good luck.

John

Re: trying to acces NSR 1200 on MSL 6000

Eric_de_Lange — Thu, 15 Sep 2011 10:02:34 GMT

One comment: the part number I have quoted comes from the MSL6000 Service Guide and specifically is for the NSR.

-Eric