https://community.hpe.com/t5/automated-backup/dlt-718-problem/m-p/116413#M251 My DLT 718 does not work properly on my Windows NT 4.0 server, sometimes DLT recognize by server and the other time DLT unrecognize, so if I check via backup software, the drive Offline status. Please advise me about this problem, Thank you Tue, 06 Aug 2002 02:54:01 GMT Dudi_1 2002-08-06T02:54:01Z https://community.hpe.com/t5/automated-backup/dlt-718-problem/m-p/116413#M251 My DLT 718 does not work properly on my Windows NT 4.0 server, sometimes DLT recognize by server and the other time DLT unrecognize, so if I check via backup software, the drive Offline status. Please advise me about this problem, Thank you Tue, 06 Aug 2002 02:54:01 GMT https://community.hpe.com/t5/automated-backup/dlt-718-problem/m-p/116413#M251 Dudi_1 2002-08-06T02:54:01Z https://community.hpe.com/t5/automated-backup/dlt-718-problem/m-p/116414#M252 If the problem is intermittent, it may be an issue with cabling or termination. <BR /> <BR /> Is this a single ended or HVDS 718? <BR /> <BR /> Does the library display report any errors? It normally says 'Loader Ready' on the lower line of the display.<BR /> <BR /> You can install HP Library &amp; Tape Tools (<A href="http://www.hp.com/support/tapetools" target="_blank" rel="nofollow">www.hp.com/support/tapetools</A>) and see if it recognizes the library and drive. If so, you can run the connectivity test and perhaps the drive read/write test (after loading a tape through the library front panel).<BR /> Wed, 07 Aug 2002 23:19:09 GMT https://community.hpe.com/t5/automated-backup/dlt-718-problem/m-p/116414#M252 CA713937 2002-08-07T23:19:09Z