https://community.hpe.com/t5/automated-backup/dl380-and-storageworks1-8/m-p/240025#M479 I purchased a HP Proliant DL380 and Storageworks autoloader 1/8. The server will recognize the device at boot, if I use the onboard SCSI. However, it does not support multiple LUNs (Unless there is a patch available) I have tried installing an additional adaptec controller (2940UW Pro), but it fails on the scsi scan. Running Netware 6. Anybody have a solution this trio? Tue, 01 Jul 2003 01:41:11 GMT Doug Barshaw 2003-07-01T01:41:11Z https://community.hpe.com/t5/automated-backup/dl380-and-storageworks1-8/m-p/240025#M479 I purchased a HP Proliant DL380 and Storageworks autoloader 1/8. The server will recognize the device at boot, if I use the onboard SCSI. However, it does not support multiple LUNs (Unless there is a patch available) I have tried installing an additional adaptec controller (2940UW Pro), but it fails on the scsi scan. Running Netware 6. Anybody have a solution this trio? Tue, 01 Jul 2003 01:41:11 GMT https://community.hpe.com/t5/automated-backup/dl380-and-storageworks1-8/m-p/240025#M479 Doug Barshaw 2003-07-01T01:41:11Z https://community.hpe.com/t5/automated-backup/dl380-and-storageworks1-8/m-p/240026#M480 Doug.<BR /> <BR /> This is apparently an issue with the SCSI card being configured for using "Multi LUNs".<BR /> I am reliably informed this is turned off by default in the 29XX series from Adaptec.<BR /> <BR /> First thing to check, on boot enter the SCSI card config and scan for devices. You should see both the SCSI ID and the LUN.<BR /> If you only see the SCSI ID of the tape device, reconfigure the card until both are present.<BR /> <BR /> Secondly check for the Std SCSI ID conflicts etc.<BR /> <BR /> All should work on the HW as described.<BR /> <BR /> Good Luck.<BR /> Trevor.<BR /> Wed, 02 Jul 2003 02:04:50 GMT https://community.hpe.com/t5/automated-backup/dl380-and-storageworks1-8/m-p/240026#M480 Trevor Roddam 2003-07-02T02:04:50Z